FUEL SYSTEM AND THROTTLE BODY 7-21
• Apply a small quantity of grease to the shaft end and seal lip.
W 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• With the TV fully closed, install the TP sensor to the original
setting position.
! TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
• Install the IAC valve.
• Apply thin coat of the engine oil to the new O-ring.
• Install the injector seal
1 and O-ring
2 to each fuel injector.
• Apply thin coat of the engine oil to the new O-ring and new seal.
• Install the fuel injectors by pushing them straight to each throt-
tle body.
• Install the fuel delivery pipe assembly to the throttle body
assembly.
• Tighten the fuel delivery pipe mounting screws.
! Fuel delivery pipe mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
Replace the O-ring with a new one.
Replace the injector seal and O-ring with the new
ones. Never turn the injector while pushing it.
Never turn the fuel injectors while installing fuel deliv-
ery pipe.
To Next Page
Loading...
