3-34 ENGINE
NOTE:
* Apply engine oil to the shim and tappet before fitting them.
* When seating the tappet shim, be sure the figure printed sur-
face faces the tappet. (2-9)
INTAKE PIPE
• Coat the O-ring with grease and install the intake pipe
together with the O-ring.
W 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
CYLINDER
• Disconnect the water pipe
1 and remove the O-ring.
• Untighten the thermostat case bolt.
• Remove the thermostat
2.
CYLINDER DISTORTION
• Check the gasket surface of the cylinder for distortion with a
straightedge and thickess gauge, taking a clearance reading
at several places as indicated.
• If the largest reading at any position of the straightedge
exceeds the limit, replace the cylinder.
[ 09900-20803: Thickness gauge
Cylinder distortion:
Service Limit: 0.10 mm (0.004 in)
To Next Page
Loading...
