10-24 ELECTRICAL SYSTEM
OPERATING PROCEDURE
INITIAL DISPLAY
When the ignition switch is set to ON, all LCD (Liquid Crystal
Display) and engine coolant temp. Indicator, FI indicator and
shift indicator lights light up for two seconds.
The tachometer light up for 0.5 second and then it operates 0 ↔
10 000 r/min two times.
NOTE:
If the power supply is cut (e.g., when the battery is replaced);
Since the clock resets to “AM1:00”, it will need to be readjusted.
CHANGE THE DISPLAY MODE
With each press of the SELECT button, the display changes
between odometer, tripmeter A and tripmeter B as shown.
"
ODOMETER
Displays the total distance travelled.
TRIPMETER
Displays the distance travelled since the tripmeter was last
reset.
NOTE:
The tripmeters A and B can be used independently.
Hold down the RESET button over two seconds to reset the trip-
meter.
CLOCK
Displays the time (hour and minutes) on a 12-hour clock.
Setting the time (Ignition switch is “ON” position)
Press the “H” button to adjust the hour display.
Press the “M” button to adjust the minute display.
Odometer Tripmeter A Tripmeter B
To aboid riding with only one hand, do not operate the
button while riding.
To Next Page
Loading...
