10-34 ELECTRICAL SYSTEM
RELAYS
TURN SIGNAL RELAY
INSPECTION
Before removing the turn signal relay, check the operation of the
turn signal light.
If the turn signal light does not illuminate, inspect the bulb, turn
signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are OK, the
turn signal relay may be faulty; therefore, replace the turn signal
relay with a new one.
NOTE:
Make sure that the battery is fully charged.
COOLING FAN MOTOR RELAY
• Remove the cooling fan motor relay. (10-4)
First check the insulation between
A and
B terminals with the
tester. Then apply 12 V to terminals as shown and check the
continuity between
A and
B. If there is no continuity, replace
the side-stand relay with a new one.
FUEL PUMP RELAY
10-28
SIDE-STAND RELAY
10-16, 10-17
STARTER RELAY
10-15
SWITCHES
IGNITION SWITCH REMOVAL
9-19
To Next Page
Loading...
