3-56 ENGINE
CRANKCASE
OIL PRESSURE SWITCH
• Remove the oil pressure switch.
• When installing the switch, apply SUZUKI BOND “1207B”.
! Oil pressure switch: 13 N·m (1.3 kgf-m, 10.0 lb-ft)
C 99104-31140: SUZUKI BOND “1207B” (USA)
99000-31140: SUZUKI BOND “1207B” (Others)
• Remove the right crankcase cover
1.
• Remove the primary shaft cap
2.
• Install the right crankcase cover
1 and primary shaft cap
2.
! Right crankcase cover bolt: 11 N·m (1.1 kgf-m, 8 lb-ft)
Primary shaft cap bolt: 11 N·m (1.1 kgf-m, 8 lb-ft)
BEARING DISASSEMBLY
• Remove the bearings with the special tool.
[ 09921-20240: Bearing remover set . . . . . . . . . . . . . . .
1
09941-54911: Bearing outer race remover . . . . . . . . .
2
To Next Page
Loading...
