CVT 5-19
CVT REASSEMBLY
PRIMARY PULLEY ASSEMBLY
• Degrease the inside of the CVT cover and CVT casing com-
pletely with a cleaning solvent by using a clean rag.
• Install the O-ring
1 and shim
2.
• Turn the slide pulley gear and close the primary pulley.
• Align the cutaway
B of the screw shaft with the protrusion
A.
Wear clean protective gloves.
If any of the primary pulley, CVT casing or CVT cover
has been replaced, install the shim whose thickness
has been adjusted in the shim adjustment procedure.
Degrease the primary pulley faces completely.
To Next Page
Loading...
