Suzuki AN650 2002 - Page 152

5-18 CVT
SHIM SELECTION
• Get the average depth Da by averaging D
1
, D
2
and D
3
.
• Get the average height Ha by averaging H
1
, H
2
and H
3
.
• Obtain the valve X by subtracting Da from Ha.
• Using the chart below, select the appropriate shim with reference to the value X.
SHIM SELECTION TABLE
NOTE:
The shims are available as a set (21746-10G00).
EXAMPLE:
SHIM THICKNESS VALUE X
0.12 mm (0.005 in) 3.12 – 3.31 mm (0.123 – 0.130 in)
0.32 mm (0.013 in) 3.32 – 3.51 mm (0.131 – 0.138 in)
0.52 mm (0.020 in) 3.52 – 3.71 mm (0.139 – 0.146 in)
0.72 mm (0.028 in) 3.72 – 3.91 mm (0.147 – 0.154 in)
0.92 mm (0.036 in) 3.92 – 4.11 mm (0.155 – 0.162 in)
1.12 mm (0.044 in) 4.12 – 4.31 mm (0.163 – 0.170 in)
1.32 mm (0.052 in) 4.32 – 4.51 mm (0.171 – 0.178 in)
CVT cover depth D
D
1
= 125.35 mm (4.935 in)
D
2
= 125.15 mm (4.927 in)
D
3
= 125.25 mm (4.931 in)
Average depth
Da = (125.35 + 125.15 + 125.25) ÷ 3
= 125.25 mm (4.931 in)
Primary pulley height H
H
1
= 121.45 mm (4.781 in)
H
2
= 121.60 mm (4.787 in)
H
3
= 121.45 mm (4.781 in)
Average height
Ha = (121.45 + 121.60 + 121.45) ÷ 3
= 121.50 mm (4.783 in)
Value
X=Da – Ha
= 125.25 mm (4.931 in) – 121.50 mm (4.783 in)
= 3.75 mm (0.148 in)
* Slelect the 0.72 mm (0.028 in) shim.