CVT 5-17
• Tighten the primary pulley shaft bolt to the specified torque
with the special tools.
! Primary pulley shaft bolt: 64 N·m (6.4 kgf-m, 46.5 lb-ft)
[ 09920-31010: CVT primary pulley shaft holder
09920-31020: Extension handle
• Fix the CVT casing securely with its mating face positioned
horizontally.
• With the straightedge placed on the casing mating face, mea-
sure the height H to the face
B of the primary pulley assem-
bly using the vernier calipers.
• Measure the height H at three points and note the measured
value H
1
, H
2
and H
3
.
[ 09900-20102: Vernier calipers
DH
To Next Page
Loading...
