3-22 ENGINE
ENGINE COMPONENT INSPECTION
AND SERVICE
CYLINDER HEAD COVER
• Remove the PAIR reed valve cover
1, cam position sensor
2 and breather cover
3.
INSPECTION
• Inspect the reed valve for the carbon deposit.
• If the carbon deposit is found in the reed valve, replace the
reed valve with a new one.
REASSEMBLY
• Apply THREAD LOCK “1342” to the thread and install the
PAIR reed valve cover.
I 99000-32050: THREAD LOCK “1342”
• Check for stain and clogging in the breather and clean as
required.
• Assemble a new gasket and breather cover and tighten the
part
A together with the clamp.
! Tightning torque: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Identify the position of each removed part. Organize
the parts in their respective groups (i.e., intake,
exhaust, No.1 or No.2) so that they can be installed in
their original locations.
To Next Page
Loading...
