Suzuki AN650 2002 - Page 358

9-86 CHASSIS
• Install the brake-lock cable.
(CABLE ROUTING: 11-18)
• Turn the nut
7 until the clearance is 0 mm (0 in).
• Connect the brake-lock cable to the brake-lock lever assem-
bly.
• Fit the nut
8 into the concavity on the brake-lock lever
assembly.
• Tighten the locknut
9 securely.
• Be sure to fit the boot
0 on the brake-lock cable.
• Connect the brake-lock cable and install the E-ring
B.
• Be sure to the dust boots
C on the brake-lock cable.
• Install the brake-lock arm
D. (9-82)
NOTE:
The open end of spring
E must face to the right side of vehicle.
• Install the brake hose clamp.
• Adjust the brake-lock. (9-84)
• Install the front box and right leg side shield.
Clearance