9-24 CHASSIS
HANDLEBAR COVER
After installing the handlebar covers, inspect clearance between
the handlebar cover
1 and the front panel
2/meter panel
3. If
the clearance is less than 5 mm (0.2 in), adjust the handlebar
position by rotating the handlebar so that the clearance would
be more than 5 mm (0.2 in) all around the handlebar cover.
• Measure the clearance between the handlebar cover and the
front panel/meter panel before removing the handlebar cov-
ers.
• Remove the handlebar covers. (9-8)
• Loosen the handlebar clamp bolts
4.
• Rotate the handlebar according to the clearance measured
above.
NOTE:
When rotating the handlebar by 0.5 mm (0.02 in) at the punch
mark, the clearance would be varied as follows.
A 4.7 mm (0.19 in) at front end of handlebar cover
B 7.3 mm (0.29 in) at rear end of handlebar cover
• Tighten the handlebar clamp bolts to the specified torque.
! Handlebar clamp bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the handlebar covers.
• Inspect the clearance.
NOTE:
* First tighten the bolt
5, and then tighten the bolt
6.
* Because of above adjustment, it is possible that the punch
mark on the handlebars is out of alignment with the mating
surface of handlebar holder.
Handlebars
Steering stem
upper bracket
Clearance
Clearance
Forward
Handlebar
cover
Front panel
Forward
Meter
panel
Punch mark
To Next Page
Loading...
