CHASSIS 9-69
CALIPER HOLDER
• Apply THREAD LOCK SUPER “1303” to the pin
2.
F 99000-32030: THREAD LOCK SUPER “1303”
• Tighten the pin
2 to the caliper holder
1 to the specified
torque.
! Caliper holder pin: 13 N·m (1.3 kgf-m, 9.5 lb-ft)
• Apply SUZUKI SILICONE GREASE to the brake caliper
holder pin
2.
Z 99000-25100: SUZUKI SILICONE GREASE
• Be sure to check that the boot is fitted on the slide pin.
• Install the pad spring
3.
• Install the brake pads. (9-64)
NOTE:
Before remounting the caliper, push the piston all the way into
the caliper.
• Remount the brake caliper to the front fork.
• Tighten each bolt to the specified torque.
! Front brake caliper mounting bolt
4:
26 N·m (2.6 kgf-m, 19.0 lb-ft)
Front brake hose union bolt
5:
23 N·m (2.3 kgf-m, 16.5 lb-ft)
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the cal-
iper. (2-24)
* Brake fluid, if it leaks, will interfere with safe running
and discolor painted surfaces. Check the brake hose
and hose joints for cracks and fluid leakage.
To Next Page
Loading...
