Suzuki AN650 2002 - Page 352

9-80 CHASSIS
• Turn the piston clockwise fully.
• Install the pad spring
1.
CALIPER HOLDER
• Apply THREAD LOCK SUPER “1303” to the sliding pins.
F 99000-32030: THREAD LOCK SUPER “1303”
• Tighten the sliding pins
1, 2 to the specified torque.
! Caliper sliding pin
1: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Caliper sliding pin
2: 13 N·m (1.3 kgf-m, 9.5 lb-ft)
• Apply SUZUKI SILICONE GREASE to the sliding pin.
Z 99000-25100: SUZUKI SILICONE GREASE
• Install the caliper holder to the caliper.
• Set the boot onto the sliding pin securely.
• Install the brake pad. (9-75)