Suzuki AN650 2002 - Page 354

9-82 CHASSIS
• Apply SUZUKI SILICONE GREASE to the brake-lock shaft.
Z 99000-25100: SUZUKI SILICONE GREASE
• Install the brake-lock shaft so that the punch mark
B can be
positioned in
C when the brake-lock shaft is turned clockwise
until it stops.
• Install the brake-lock cable and E-ring.
• Install the brake-lock adjust bolt
1 to the brake-lock shaft.
• Turn the brake-lock shaft about 90 degree counterclockwise
so that the punch mark
D will face upward.
• Install the brake-lock arm
2 with the punch mark E aligned
with the punch mark
F on the brake-lock arm 2.
• Hook the spring and connect the brake arm
2 with the brake-
lock cable.
NOTE:
Make sure that the spring end faces to right side of the vehicle.
• Adjust the brake-lock. (9-85)