Suzuki AN650 2002 - Page 57

3-6 ENGINE
• Disconnect the engine ground lead wire.
• Disconnect the center stand switch lead wire coupler
1, CVT
pulley position sensor lead wire coupler
2, CVT motor lead
wire coupler
3, CVT scondary pulley revolution sensor lead
wire coupler
4 and HO2 sensor lead wire coupler 5.
• Disconnect the starter motor lead wire.
• Disconnect the ECT sensor coupler
6.
• Disconnect the side-stand switch lead wire coupler
7, oil
pressure switch lead wire coupler
8, oil level switch lead wire
9, CKP sensor coupler 0 and trunk light seat switch lead
coupler
A.
• Disconnect the CMP sensor coupler
B.
• Remove the ignition coil/spark plug cap.