ENGINE 3-29
VALVE GUIDE SERVICING
• Using the valve guide remover, drive the valve guide out
toward the intake or exhaust camshaft side.
[ 09916-53310: Valve guide remover/installer
NOTE:
* Discard the removed valve guide subassemblies.
* Only oversized valve guides are available as replacement
parts. (Part No. 11115-33D71)
• Refinish the valve guide holes in cylinder head with the
reamer and handle.
[ 09916-34561: Valve guide reamer
09916-34542: Reamer handle
• Apply engine oil to the valve guide hole.
• Drive the valve guide into the hole using the special tool.
[ 09916-43210: Valve guide installer/remover
NOTE:
Install the valve guide until the attachment contacts with the cyl-
inder head.
[ 09916-43210: Valve guide remover/installer
09916-44930: Valve guide installer attachment
• After installing the valve guides, refinish their guiding bores
using the reamer.
• Clean and oil the guides after reaming.
[ 09916-33310: Valve guide reamer
09916-34542: Valve guide reamer handle
NOTE:
Insert the reamer from the combustion chamber and always turn
the reamer handle clockwise.
When refinishing or removing the reamer from the
valve guide hole, always turn it clockwise.
Failure to oil the valve guide hole before driving the
new guide into place may result in a damaged guide or
head.
Valve guide
Cylinder head
To Next Page
Loading...
