ENGINE 3-39
• Remove the spring seat and concaved washer.
• Remove the outer plate, driven plate No.1, clutch plate con-
caved washer, drive plate and driven plate No.2.
• Remove the clutch spring bolts
2, springs
3 and clutch inner
plate
4.
• Remove the rollers.
CLUTCH DRIVE PLATES/CLUTCH DRIVEN PLATES NO.2
INSPECTION
NOTE:
Wipe off engine oil from the clutch drive plates with a clean rag.
• Measure the thickness of drive plates with a vernier calipers.
• If each drive plate thickness is less than the limit, replace it
with a new one.
Drive plate thickness:
Service Limit: 2.62 mm (0.095 in)
Driven plate No.2 thickness:
Service Limit: 2.27 mm (0.0894 in)
[ 09900-20102: Vernier calipers
To Next Page
Loading...
