Suzuki GSX-R1000K5 - Page 146

3-92 ENGINE
OIL PUMP
• Install the O-ring to the oil pump and apply SUZUKI SUPER
GREASE “A” to it.

NOTE:
Set the oil pump shaft end A to the water pump shaft.
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the oil pump with the oil pump mounting bolts and then
tighten them to the specified torque.
 Oil pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the washer 1 and pin 2.
NOTE:
Be careful not to drop the washer 1 and pin 2 into the crank-
case.
• Install the oil pump driven gear 3.
• Install the snap ring 4.
CLUTCH
NOTE:
Before assembling the clutch, adjust the clutch lifter. (3-45)
• Install the thrust washer onto the countershaft.
NOTE:
The chamfer side A of thrust washer faces inside.
Use a new O-ring to prevent oil leakage.
SAMPLE