ENGINE 3-93
• Install the oil pump drive gear 1 to the primary driven gear
assembly 2.
• Install the primary driven gear assembly 2.
NOTE:
* If it is difficult to install the primary driven gear, rotate the
crankshaft.
* Be sure to engage the oil pump driven gear with the drive gear
and the primary driven gear with the drive gear.
• Install the bearing 3 and spacer 4, and apply engine oil to
them.
• Install the thrust washer 5.
• Install the wave spring washers 6, clutch lifter driven cam 7
and clutch lifter drive cam 8 to the clutch sleeve hub 9.
NOTE:
* Apply a small quantity of MOLYBDENUM OIL SOLUTION to
the contact surfaces of the clutch lifter drive cam 8 and driven
cam 7.
* Be sure to align the punch marks A on the clutch lifter drive
cam 8 and driven cam 7.
MOLYBDENUM OIL SOLUTION
SAMPLE
To Next Page
Loading...
