3-70 ENGINE
• With the rear output shaft held immovable with a vise, tighten
the new nut to the specified torque.
# Rear output shaft nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
NOTE:
Do not stake a lock portion on the nut at this stage. After the
backlash and tooth contact have been checked or adjusted,
stake the nut with a center punch.
• Apply grease to the bearing and its dust seal lip.
• Install the universal joint and bearings with the special tool.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
( 09913-70210: Bearing installer set
NOTE:
After the backlash and tooth contact have been checked or
adjusted, reassemble the universal joint.
• Install the C-rings by tapping with a copper hammer as
shown.
"
• After reassembling the universal joint, check the joint move-
ment smoothly. If a large resistance is felt to movement, tap
the bearing with a plastic mallet lightly.
Replace the removed C-ring with a new one.
To Next Page
Loading...
