ENGINE 3-71
• Install the driven bevel gear, bearing, washer and nut.
NOTE:
The wider side
A of the bearing should be positioned driven
bevel gear side.
• With the rear output shaft held immovable with a vise, tighten
the new nut to the specified torque.
# Final driven bevel nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Stake the nut with a center punch.
Front output shaft
• Install the bearing to the shaft.
NOTE:
The bearing knock-pin
A should be positioned inside.
• Apply grease to the lip of the oil seal.
• Install the oil seal to the joint yoke.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
NOTE:
The lip
B of the oil seal should be positioned joint yoke side.
To Next Page
Loading...
