3-72 ENGINE
• With the front output shaft held immovable with a vise, tighten
the new nut to the specified torque.
# Front output shaft nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Stake the nut with a center punch.
• Apply grease to the bearing and dust seal lip.
• Install the universal joint and bearings with the special tool.
(!3-70)
• Install the C-rings by tapping with a copper hammer.
(!3-70)
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
( 09913-70210: Bearing installer set
NOTE:
Reassemble the universal joint in the same manner as the rear
one. (!3-70)
• After reassembling the universal joint, check the joint move-
ment smoothly. If a large resistance is felt to movement, tap
the bearing with a plastic mallet lightly.
To Next Page
Loading...
