ENGINE 3-85
• Install the washer
1 and pin
2.
• Install the oil pump driven gear by installing the snap ring.
OIL PUMP DRIVE GEAR
• Install the spacer
1 and pin
2.
• Install the oil pump drive gear
3 and washer
4.
NOTE:
Flange side of the gear is positioned inside.
• Tighten the oil pump drive gear nut to the specified torque
with the special tool.
# Oil pump drive gear bolt: 80 N·m (8.0 kgf-m, 58.0 lb-ft)
( 09930-40113: Rotor holder
CAM CHAIN
• Install the cam chain.
GEARSHIFT
• Install the gearshift cam plate
1.
To Next Page
Loading...
