3-84 ENGINE
NEUTRAL SWITCH
• After positioning the spring and switch contact
1, install the
switch body with a new O-ring
2.
GENERATOR
• Install the washer
1.
• Install the starter driven gear
2.
• Install the key
3.
NOTE:
Degrease the tapered portion of the generator rotor assembly
and also the crankshaft. Use nonflammable cleaning solvent to
wipe off the oily or greasy matter to make these surfaces com-
pletely dry.
• Install the generator rotor assembly.
"
• Tighten the generator rotor nut to the specified torque with the
special tool.
# Generator rotor nut: 160 N·m (16.0 kgf-m, 115.5 lb-ft)
( 09930-44541: Rotor holder
OIL PUMP
• Apply engine oil to the sliding surfaces of the case, outer
rotor, inner rotor and shaft.
• Install the oil pump.
• Apply THREAD LOCK “1342” to the screws and tighten them.
& 99000-32050: THREAD LOCK “1342”
Make sure that the one way clutch on the crankshaft is
fitted into the generator rotor properly.
To Next Page
Loading...
