ENGINE 3-83
• Apply SUZUKI BOND “1207B/1215” to the mating surface of
the right crankcase.
+ 99104-31140: SUZUKI BOND “1207B” (USA)
, 99000-31110: SUZUKI BOND “1215” (Others)
• Assemble the crankcase within few minutes.
• Tighten the crankcase securing bolts for right side.
# Crankcase bolt (6 mm): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Crankcase bolt (8 mm): 22 N·m (2.2 kgf-m, 16.0 lb-ft)
• Tighten the crankcase securing bolts for left side.
# Crankcase bolt (6 mm): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Crankcase bolt (8 mm): 22 N·m (2.2 kgf-m, 16.0 lb-ft)
NOTE:
After the crankcase bolts have been tightened, check if the each
shaft rotates smoothly. If a large resistance is felt to rotation, try
to free the shafts by tapping them with a plastic mallet.
REVERSE CAM STOPPER BOLT
• Apply grease to the reverse cam stopper pin.
• Tighten the reverse cam stopper bolt
1.
# Stopper bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
To Next Page
Loading...
