3-82 ENGINE
• Install the gearshifting fork shafts
F.
• After installing the gearshift forks and gears, turn the gearshift
cam and check to see that gears engage positively.
NOTE:
After the gearshifting fork shafts and gearshifting forks have
been fitted, confirm that gear change is normal while turning the
countershaft and driveshaft. If gear change is not obtained, it
means that assembly of gears or installation of gearshifting fork
is incorrect. If this is the case, disassemble and trace the mis-
take.
SECONDARY DRIVEN OUTPUT SHAFT
• When installing the secondary driven output shaft assembly,
be sure to install the C-ring
1 for the main bearing and place
the pin
2 to the groove for the front side bearing and the pin
3 to the groove for the rear side bearing.
CRANKCASE
• Wipe the crankcase mating surfaces (both surfaces) with a
cleaning solvent.
• Fit the dowel pins and O-ring
A onto the left half on the
crankcase.
• Apply engine oil to the conrod big end and the gears.
NOTE:
Coat the O-ring
A of crankcase with grease.
To Next Page
Loading...
