ENGINE 3-89
• Install the primary driven gear assembly together with the
clutch wheel.
• Install the washer
6 and clutch sleeve hub nut.
NOTE:
The convex side of the washer faces outside.
• Tighten the clutch sleeve hub nut to the specified torque with
the special tool.
# Clutch sleeve hub nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
( 09920-53730: Clutch sleeve hub holder
• Stake the clutch sleeve hub nut with a center punch.
• Install the one-way clutch with facing the “OUTSIDE” mark
outside.
• Install the clutch shoe assembly.
• Install the washer
7 and clutch shoe nut.
NOTE:
The convex side of the washer faces outside.
INSIDE
Washer
OUTSIDE
INSIDE
Washer
OUTSIDE
To Next Page
Loading...
