3-102 ENGINE
CAMSHAFT
• Align the line
A on the generator rotor with the index mark
B
on the crankcase.
"
• Align the marks
A on the camshaft so that they are parallel
with the surface of the cylinder head.
NOTE:
Do not rotate the generator while doing this. When the sprocket
is not positioned correctly, turn the sprocket.
• Engage the locating pin
D on the camshaft with the hole as
shown.
• Recheck the position of the line
A and marks
C.
• Install the lock washer so that it is covering the locating pin.
• Apply THREAD LOCK SUPER “1303” to the bolts and tighten
them to the specified torque.
# Camshaft sprocket bolt: 15 N·m (1.5 kgf-m, 11.0 lb-ft)
$ 99000-32030: THREAD LOCK SUPER “1303”
• Bend up the washer tongue positively to lock the bolts.
Pull the cam chain upward, or the chain will be caught
between crankcase and cam drive sprocket.
Camshaft
Pin
Bend up
Bolt
Washer
Sprocket
To Next Page
Loading...
