ENGINE 3-103
• Install the C-ring
1.
CYLINDER HEAD COVER
• Clean the mating surface of the cylinder head and head cover
before matching.
• Install the dowel pins to the cylinder head.
• Apply engine oil to the cam face and camshaft journal.
• Apply SUZUKI BOND “1216B” to the mating surface of the
cylinder head cover. (!3-104)
• Fit the camshaft end cap
1.
99000-31230: SUZUKI BOND “1216B”
• Lightly tighten the cylinder head cover bolts diagonally, and
then if everything is satisfactory, tighten securely with a
torque wrench to the specified torque.
# Cylinder head cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
When tightening the cylinder head cover bolts, the piston must
be at top dead center on the compression stroke.
1216
To Next Page
Loading...
