4-12 DRIVE TRAIN
SHIFTING SLEEVE/UNIVERSAL JOINT YOKE
• Install the shifting sleeve to the pinion gear shaft.
• Drive the new bearing into the gear case with the special tool
and fix it with the snap ring.
# 09913-70210: Bearing installer set
• Install the oil seal into the gear case with the special tool.
# 09913-70210: Bearing installer set
• Apply grease to the seal lip groove.
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Apply 4 – 5 gram of water resistance grease to the outside of
seal lip groove.
% 99000-25160: WATER RESISTANCE GREASE
• Apply grease to the bearing and dust seal lip.
• Install the universal joint and bearings with the special tool.
(!3-70)
• Install the C-rings by tapping with a copper hammer. (!3-
70)
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
# 09913-70210: Bearing installer set
NOTE:
Reassemble the universal joint in the same manner as the front/
rear output shaft.
To Next Page
Loading...
