DRIVE TRAIN 4-25
• Remove the snap ring.
• Remove the bearing out of the drive shaft housing with the
special tool.
# 09913-70210: Bearing installer set
NOTE:
If there is no abnormal condition, the bearing removal is not nec-
essary.
"
• Remove the oil seal with the special tool.
# 09913-50121: Oil seal remover
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.
"
REAR DRIVE GEAR CASE
• Remove the rear drive shaft coupling joint
1.
• Unstake the bearing locknut with a small chisel or drill.
The removed bearing must be replaced with a new
one.
The removed oil seal must be replaced with a new one.
To Next Page
Loading...
