4-26 DRIVE TRAIN
• Remove the bearing locknut with the special tool.
# 09924-41830: Bearing lock nut wrench
"
• Remove the pinion gear assembly and shims out of the case.
• Remove the eight case cover bolts diagonally and evenly.
• Pry the case cover with 5 mm screws as shown.
• Remove the ring gear, shims and washer.
• Remove the oil seal out of the cover with the special tool.
# 09913-50121: Oil seal remover
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.
"
The removed locknut must be replaced with a new
one.
The removed oil seal must be replaced with a new one.
To Next Page
Loading...
