7-80 CHASSIS
• Install the reverse gear arm
5 onto its shaft so that the setting
angle becomes approx. 42° from the horizontal to the “R”
position.
• Install the reverse switch.
$
• Install the reverse gear cable
6, washer and E-ring to the
reverse arm
2.
• Adjust the cable play. (!7-83)
$
PARKING CABLE
Before removing the parking cable, keep the gearshift lever in
the “P” position.
• Remove the tank covers, left inner fender and left mud guard.
(!7-5 to -8)
• Disconnect the parking cable
1 from the parking arm
2.
Make sure the installation angle of the reverse gear
arm is accurate.
Do not apply lateral force to the cable end. Excessive
bending of cable may result in damage of flexible joint
of cable
Washer E-ring
To Next Page
Loading...
