ENGINE 3-9
• Install the propeller shaft, front and rear.
NOTE:
Align the match marks on the front propeller shaft so that the
yoke
A would be aligned with the yoke
B as shown in illustra-
tion.
• Apply THREAD LOCK SUPER “1303” to the propeller shaft
flange coupling bolts and tighten them to the specified torque.
$ 99000-32030: THREAD LOCK SUPER “1303”
# Front propeller shaft flange coupling bolt:
45 N·m (4.5 kgf-m, 32.5 lb-ft)
Rear propeller shaft flange coupling bolt:
30 N·m (3.0 kgf-m, 21.5 lb-ft)
• Install the brake pedal by aligning the punched mark on the
shaft with the slit of the pedal.
• Apply THREAD LOCK SUPER “1303” to the bolts (M10 only)
and tighten them to the specified torque.
$ 99000-32030: THREAD LOCK SUPER “1303”
# Footrest bolt: 8 mm: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
10 mm: 55 N·m (5.5 kgf-m, 40.0 lb-ft)
Pin
Match mark
FRONT
To Next Page
Loading...
