ENGINE 3-11
STARTER MOTOR
• Install the starter motor.
NOTE:
Apply grease to the new O-ring.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Loosen the locknuts
1 and
2.
• Rotate the adjusting screw
3 counterclockwise until it stops.
• Tighten the locknut
1.
• Rotate the adjusting screw
3 clockwise 1/4 – 2/4 turn back.
• Tighten the locknut
2 by holding the adjuster screw
3.
# Locknut
1: 8 N·m (0.8 kgf-m, 5.7 lb-ft)
Locknut
2: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Apply SUZUKI SUPER GREASE “A” to the O-ring and install
the clutch adjuster cap.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• After installing the engine, route the wire harness, cables and
hoses properly. (!9-12)
• Adjust the following items.
* Engine oil !2-9
* Engine coolant !2-12
* Engine idle speed !2-8
* Throttle cable play !2-8
% Engine oil capacity
Oil change: 2.5 L (2.6/2.2 US/lmp qt)
Oil and filter change: 2.7 L (2.9/2.4 US/lmp qt)
Engine overhaul: 3.2 L (3.4/2.8 US/lmp qt)
To Next Page
Loading...
