ENGINE 3-53
• Remove the output shaft with a plastic mallet.
DRIVE BEVEL GEAR REASSEMBLY
• Install the output shaft with a plastic mallet.
• Install the shim
1.
• Install the drive bevel gear and washer
2.
• Hold the output shaft with the special tool.
( 09930-73150: Output shaft holder
• Tighten the drive bevel gear nut to the specified torque.
# Drive bevel gear nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
To Next Page
Loading...
