15 - Messages
The following is a list of messages that appear in pop-up windows.
Refer to this list if one of these pop-up messages appears on the Model 2400 and you want to check the meaning or determine a proper
response.
Message Meaning and response
Card Error The SD card cannot be recognized properly. Replace the SD card.
Card Full The SD card has no remaining capacity.
Dup File Name A le with the same name already exists. Change the le name.
File Not Found The le cannot be found or the le may be damaged. Check the relevant le.
No sys le
Make sys le
The system le is missing. This unit requires a system le for operation.
When this message appears, press the MULTI JOG dial to create a system le.
Song Protected This operation is not possible because the song is protected. Remove protection.
Invalid Card
Change Card
Something might be wrong with the SD card. Change the SD card.
I/O Too Short
On the AUTO PUNCH Screen, the time between the punch in and out points is too short. Set
them with at least 1 second between them.
MBR error
Init card
The SD card is not formatted properly or the card is broken.
Change the SD card or press the MULTI JOG dial while this message is being shown to format the
card.
Formatting will erase all the data on the SD card.
No Card
A SD card is not set.
Insert a recordable SD card.
Non-supported
The le format is not supported. Please see “Playing WAV les on SD cards (SD PLAY mode)” on
page 53 for le formats that this unit can use.
Card Protected The SD card is write-protected. Disable SD card write-protection.
USB Fs mismatch
The sampling rate of the current song and the USB audio interface are not the same.
Change the sampling rate of one so that they are the same.
Current Song The current song cannot be deleted. To delete the current song, load another song rst.
Invalid I/O point
The punch in/out point settings on the AUTO PUNCH Screen are not set correctly.
Automatic punching in/out occurred at an invalid position for the punch in or out point.
Start the automatic punch operation from a valid point.
Write error
REC continue
Writing to the SD card timed out. This has caused audio to be interrupted and noise to occur.
REC stop
Card slow
Writing to the SD card timed out, and recording stopped.
SD card writing performance has become worse.
Execute the erase format function or change the SD card.
Need to set
I/O point.
Neither the punch in or out points are set for the automatic punch in/out function.
Either the punch in or out point must be set.
Sample rate
Unmatch
The sampling frequency of the WAV le to be imported does not match the current song.
Select a WAV le with the same sampling frequency as the current song or convert the sampling
frequency before importing.
Remain time is
not enough
The SD card does not have enough open space, so importing is not possible.
Erase unnecessary les or transfer them to a computer.
8 track
punch in limit
The maximum number of tracks for punch in recording is eight.
Press REC buttons to reduce the number of recording tracks to eight or less.
Song is not
loaded
No song is loaded.
Create a new song or load a song.
Song number full
The maximum number of songs that can be created on an SD card is 100.
Erase unnecessary songs.
SD PLAY:
cannot record
SD PLAY mode is for playback only.
Recording is not possible.
SD CARD cluster
size error
Recording is not possible because the SD card cluster size is not right.
Back up the contents of the SD card on a computer and then format it with this unit.
Then, restore the data from the computer.
Import error.
No track
Importing is not possible because there are no open tracks.
Use TRACK CLEAR to clear a track. (see "Clearing tracks" on page 37.)
Invalid track
The selected track cannot be used for replacement.
Change the track selection on the TRACK SWAP screen. (see "Swapping tracks" on page 38.)
Already protected The selected song is already protected.
66 TASCAM Model 2400
To Next Page
