ETH COMMANDS
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
297
eth Commands
eth bridge add Add a new bridge instance. see page 302
eth bridge clear Clear bridge statistics. see page 303
eth bridge config Modify/Display the bridge configuration
settings.
see page 304
eth bridge delete Delete a bridge instance. see page 305
eth bridge dynvlan actlist Display the active MAC entries for the dynamic
VLAN membership.
see page 306
eth bridge dynvlan add Add a dynamic VLAN membership entry. see page 307
eth bridge dynvlan config Modify the dynamic VLAN membership
configuration.
see page 308
eth bridge dynvlan delete Delete a dynamic VLAN membership entry. see page 309
eth bridge dynvlan flush Flush all dynamic VLAN membership entries. see page 310
eth bridge dynvlan list Display a dynamic VLAN membership entry. see page 311
eth bridge filter add Add a filter. see page 312
eth bridge filter attach Enable a filter. see page 313
eth bridge filter config Change filter configuration see page 314
eth bridge filter delete Delete a filter. see page 315
eth bridge filter detach Disable a filter. see page 316
eth bridge filter forwarding Action: set forwarding configuration. see page 317
eth bridge filter fwdintfadd Add Forwarding interface: filter action. see page 318
eth bridge filter fwdintfdel Remove Forwarding interface: filter action. see page 319
eth bridge filter ifadd Connect an interface with a filter. see page 320
eth bridge filter ifdel Remove an interface from a filter. see page 321
eth bridge filter list Display the bridge filters. see page 322
eth bridge flush Flush all bridge instances with their interfaces
and properties.
see page 323
eth bridge ifadd Add a new bridge interface. see page 324
eth bridge ifattach Attach a bridge interface. see page 325
eth bridge ifconfig Modify a bridge interface configuration. see page 326
eth bridge ifdelete Delete a bridge interface. see page 328