GRP COMMANDS
460
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
grp config
Set the grp configuration settings.
SYNTAX:
grp config [cdistance = <number{0-255}>]
[kdistance = <number{0-255}>]
[rdistance = <number{0-255}>]
[trace = <{disabled|enabled}>]
where:
cdistance Set the distance of the connected route type. Default
distance is 0.
OPTIONAL
kdistance Set the distance of the kernel route type. Default distance is
1.
OPTIONAL
rdistance Set the distance of the RIP route type. Default distance is
120.
OPTIONAL
trace Enable/Disable tracing. OPTIONAL
To Next Page
Loading...
