Technicolor TG582n Cli Reference Guide

IP COMMANDS
520
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
ip debug sendto
Send UDP packets.
SYNTAX:
ip debug sendto addr = <ip-address>
[count = <number{1-1000000}>]
[size = <number{0-20000}>]
[interval = <number{1-1000000}>]
[listen = <{disabled|enabled}>]
[dffield = <{disabled|enabled}>]
[srcaddr = <ip-address>]
[srcport = <number{1-65535}>]
dstport = <number{1-65535}>
[dstintf = <{loop|Internet|LocalNetwork}>]
where:
addr The destination IP address. REQUIRED
count The number of datagrams to send. OPTIONAL
size The size of the datagram. OPTIONAL
interval The interval in milliseconds between datagrams. OPTIONAL
listen Don't send, just listen for incoming datagrams. OPTIONAL
dffield Enables setting of the don't fragment flag in the IP headers
of the ping packet(s).
OPTIONAL
srcaddr The IP source address to use. OPTIONAL
srcport The UDP source port number to use. OPTIONAL
dstport The UDP destination port number to send to. REQUIRED
dstintf The IP interface name. OPTIONAL

Technicolor TG582n Specifications

General

Type	ADSL Modem Router
Wi-Fi Standards	802.11b/g/n
Antenna	Internal
Security	WEP, WPA, WPA2
VoIP	No
Ethernet Ports	4
USB Ports	1 USB 2.0 port
ADSL Standards	ADSL2, ADSL2+