Technicolor TG582n - Grp Rip Ifconfig

GRP COMMANDS
464
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
grp rip ifconfig
Configure a RIP interface.
SYNTAX:
grp rip ifconfig intf = <{LocalNetwork|Internet}>
[rip = <{disabled|enabled}>]
[rxversion = <{rip_unspec|rip_v1|rip_v2|
rip_v1-2}>]
[authmode = <{none|cleartext}>]
[authstr = <password>]
[splithorizon = <{disabled|enabled}>]
where:
intf The name of the RIP interface to configure. REQUIRED
rip Enable/Disable the RIP status. OPTIONAL
rxversion Set the RIP receive version. OPTIONAL
authmode Set the RIP authentication mode. OPTIONAL
authstr Set the RIP authentication password. OPTIONAL
splithorizon Enable/Disable the split horizon status. OPTIONAL