Technicolor TG582n Cli Reference Guide

ETH COMMANDS
414
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth switch storm ifconfig
Configure per port storm control parameters.
SYNTAX:
eth switch storm ifconfig port = <number{1-4}>
[state = <{enabled|disabled}>]
[rate = <number{0-1000}>]
[burstsize = <{16|20|28|40|76|140|268|500}>]
[broadcast = <{enabled|disabled}>]
[multicast = <{enabled|disabled}>]
[unknown = <{enabled|disabled}>]
where:
port The port. REQUIRED
state Enable/disable storm control. OPTIONAL
rate Rate in 10ths of percent. OPTIONAL
burstsize Burst size in KBytes. OPTIONAL
broadcast Storm control for broadcast traffic. OPTIONAL
multicast Storm control for multicast traffic. OPTIONAL
unknown Storm control for traffic with unknown destination address. OPTIONAL

Technicolor TG582n Specifications

General

Type	ADSL Modem Router
Wi-Fi Standards	802.11b/g/n
Antenna	Internal
Security	WEP, WPA, WPA2
VoIP	No
Ethernet Ports	4
USB Ports	1 USB 2.0 port
ADSL Standards	ADSL2, ADSL2+