Technicolor TG582n Cli Reference Guide

ETH COMMANDS
362
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth device ifconfig
Configure an Ethernet port's type setting (disable/enable autonegotiation).
SYNTAX:
eth device ifconfig intf = <{ethif1|ethif2|ethif3|ethif4|}>
[state = <{enabled|disabled}>]
[type = <{auto|10BaseTHD|10BaseTFD|100BaseTHD|
100BaseTFD}>]
[mtu = <number{1518-1534}>]
where:
intf The Ethernet port's name. REQUIRED
state The port's administrative state. OPTIONAL
type The port's type setting. If auto, then autonegotiation will
be used, if something else, then autonegotiation will be
disabled. Be careful with using this command: a wrong
type setting make you loose the link. Use the autonegotian
settings command instead: this is much more reliable!
OPTIONAL
mtu The MTU for this Ethernet port. OPTIONAL

Technicolor TG582n Specifications

General

Type	ADSL Modem Router
Wi-Fi Standards	802.11b/g/n
Antenna	Internal
Security	WEP, WPA, WPA2
VoIP	No
Ethernet Ports	4
USB Ports	1 USB 2.0 port
ADSL Standards	ADSL2, ADSL2+