ETH COMMANDS
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
299
eth bridge vlan iflist Display all vitual LAN's. see page 355
eth bridge xtratag add Add an extra tag mapping entry. see page 356
eth bridge xtratag config Configure an extra tag mapping entry. see page 357
eth bridge xtratag delete Delete an extra tag mapping entry. see page 358
eth bridge xtratag flush Flush all extra tag mapping entries. see page 359
eth bridge xtratag list Display all extra tag mapping entries. see page 360
eth device ifautoneg Adapt/list an Ethernet port's autonegotiation
parameters (if autonegotiation
see page 361
eth device ifconfig Configure an Ethernet port's type setting
(disable/enable autonegotiation).
see page 362
eth device iflist Show all Ethernet ports' operational status. see page 363
eth device ifrestart Reset an Ethernet port and restart
autonegotiation.
see page 364
eth filter operand add Add a filter operand. see page 365
eth filter operand config Set the operand to a certain type (will reset
content first).
see page 366
eth filter operand delete Delete a filter operand. see page 368
eth filter operand flush Remove all filter operands (this will only delete
the ones not in use: flush
see page 369
eth filter operand frameclassadd Add another frameclass in the set. see page 370
eth filter operand frameclassdelete Delete a frameclasse from the set. see page 371
eth filter operand ipprotoadd Add another ip protocol in the set. see page 372
eth filter operand ipprotodelete Delete a ip protocol from the set. see page 373
eth filter operand list Display the filter operands. see page 374
eth filter operand priorityadd Add another priority in the set. see page 375
eth filter operand prioritydelete Delete a ip priority from the set. see page 376
eth filter operand reset Reset an operand to its default initial state
(removes all content, set to
see page 377
eth filter operand vidadd Add another VID in the set. see page 378
eth filter operand viddelete Delete a VID from the set. see page 379
eth filter template add Add a filter. see page 380
eth filter template config Config a filter. see page 381
eth filter template delete Delete a filter. see page 382
To Next Page
Loading...
Need help?
General
