15
> When you start the search using the green function key, an automatic search runs.
This will scan all the satellites set up in the antenna configuration for channels. This
procedure may take several minutes. Please note all messages displayed on screen.
Software update
After you have carried out the antenna settings, the digital receiver will check whether any
new software for the receiver is available via satellite. If a new software version is available,
you can carry out an automatic software update.
Loading EPG/SFI data
Your TV has an EPG (electronic programme guide). You must first get the receiver to download
the EPG data from the satellite to enable electronic programme guide data to be displayed.
For this reason, after the channel list update or channel search has completed, the receiver will
automatically start downloading the EPG/SFI data. This procedure can take up to 30 minutes.
> If you do not wish to wait for the EPG/SFI data to be downloaded, you can skip this
procedure. To do this, press the yellow function key (Skip).
The EPG/SFI data will then be automatically updated the following night, or you can
also update it manually at any time.
Exiting the installation wizard
> Confirm the final message in the installation wizard by pressing the green function key
Close to return to normal mode.
6 Settings
Now that you have connected your new digital receiver and begun to operate it, you can
optimise its functions to suit your preferences, if you wish.
6.1 Operating language
This menu item enables you to set the language used in all the menus according to
your preference.
6.2 Basic settings
You can use this section to configure your receiver to your preferred settings.
6.2.1 Country
This function automatically enables conversion from summer to winter time and sets the time
difference to Greenwich Mean Time.
6.2.2 Time zone
> Where the user-defined setting has been selected in Country, you only need to
adjust the time to your local time using the left/right arrow keys.
For Germany this difference is +1 hour (+2 hours in summer time).
6.2.3 Date/time
In this menu item you can decide whether the date and time should be read automatically
whenever the receiver is switched on or from a predefined channel.
ENCZSKPLHURU
To Next Page
Loading...
Need help?
General