Version: 1.06 37
6.7.3. Sending a document
In order to have the TB
OX
MS running with the program you have developed with TWinSoft,
you have to send it. You can use any media to achieve it (RS232, modem, Ethernet, …).
Possibilities for sending a program:
• Use the icon
of the main tool bar
• From the main menu use: ‘Communication’ ‘Send program’
• Use the accelerator keys <CTRL + F9>
The sequence for sending is Compiling + Sending.
If a problem occurs during compiling, the sequence is stopped and the ‘Results’ window
pops-up (see above)
If you interrupt the sending of the program or an error happens
before the end of sending, TB
OX
MS will not restart, even after a reset.
The reason is that the program is composed of several modules; when
starting, TB
OX
MS checks the integrity of those modules. When they do
not correspond to the same sending the program does not start, even
after a reset.
You have then to re-send the program.
The good news is that TB
OX
MS keeps its original settings before it
was stopped.
To Next Page
Loading...