Version: 1.06 42
8.1. General properties
RTU Type: The type of RTU you have selected with the Wizard (see chapter 6.1). It
cannot be changed!
Name: type a free name for the TB
OX
MS. It will be displayed when doing a
‘RTU identification’ and used by the supervisory T.
Maximum 8 characters.
ModBus address: with ModBus protocol, each device must have a Station number. It is its
ModBus address.
Enter a number between 1 and 255 (default=1).
Sub address: if more than 255 TB
OX
MS must be installed in one project, you need to
define a Sub address. As this is not ModBus standard, it is only supported
by ‘TComm.dll’ based software (TWinSoft, T, … please call your
distributor for further information).
Enter a number between 0 and 15 (default=0).
To Next Page
Loading...