Maintenance / Demounting
DUT-E fuel level sensors. Operation manual. Version 8.1
© Technoton, 2020 97
7.2 Demounting
Clean the tank surface nearby the mounting location before DUT-E demounting.
Prepare a clean napkin to clean the fuel from the sensor probe.
Cut the sealing cord carefully, with no damage to connection cable.
Disconnect DUT-E cable connector.
Unfasten DUT-E by turning its body counterclockwise.
Mount the fuel tank plug (be ordered separately) for protection from any possible clogging
through mounting opening.
ATTENTION:
1) To avoid any cable/PCB damage do not pull the interface cable when demounting
DUT-E.
2) In case of repeated installation of DUT-E – replace the old rubber gasket with
a new one.
To Next Page
Loading...