TeeJet RADION 8140 - Appendix B - User Setting Notes

58
INTRODUCTION
www.teejet.com
OPERATION DATA SETTINGS TOOLSCONSOLE
Radion 8140 Automatic Sprayer Control
APPENDIX
APPENDIX B – USER SETTING NOTES
Settings-> Job Parameters
Description User Setting
Target Application Rates
No. 1
No. 2
No. 3
NOTE: Go to Settings->Job Parameters->Application Rate; or go
to Settings->Machine->Implement Parameters->Tip Preset
Setup.
Settings-> Machine-> Filling
Description User Setting
Density Type
Density Factor (Fertilizer)
NOTE: Go to Operation->Filling (1) and (2) (via Tank icon) or go to
Settings->Machine->Filling (1) and (2).
Settings-> Machine-> Operation
Description User Setting
Application Rate Step
Speed Source
Simulated speed
Minimum Speed
NOTE: Go to Settings->Machine->Operation.
Settings-> Machine-> Implement Parameters
Section Conguration
Description User Setting
Number of Tips Section 1
Number of Tips Section 2
Number of Tips Section 3
Number of Tips Section 4
Number of Tips Section 5
Number of Tips Section 6
Number of Tips Section 7
Number of Tips Section 8
Number of Tips Section 9
Number of Tips Section 10
Number of Tips Section 11
Number of Tips Section 12
Number of Tips Section 13
NOTE: Go to Settings->Machine->Implement Parameters-> Section
Configuration.
The number of available sections is dependent upon the
console model.
Tip Preset Setups
Tip Preset No. 1 User Setting
Tip Series
Tip Capacity
Low Pressure Limit
High Pressure Limit
Reference Flow
Reference Pressure
Tip Preset No. 2 User Setting
Tip Series
Tip Capacity
Low Pressure Limit
High Pressure Limit
Reference Flow
Reference Pressure
Tip Preset No. 3 User Setting
Tip Series
Tip Capacity
Low Pressure Limit
High Pressure Limit
Reference Flow
Reference Pressure
Tip Preset No. 4 User Setting
Tip Series
Tip Capacity
Low Pressure Limit
High Pressure Limit
Reference Flow
Reference Pressure
Tip Preset No. 5 User Setting
Tip Series
Tip Capacity
Low Pressure Limit
High Pressure Limit
Reference Flow
Reference Pressure
NOTE: Go to Settings->Machine->Implement Parameters-> Tip
Preset Setup to access tip preset setups.
Regulation Parameters
Description User Setting
Course valve calibration
Fine valve calibration
Tip Spacing
Regulation Mode
NOTE: Go to Settings->Machine->Implement Parameters->
Regulation Parameters.