Tektronix 453 - Page 144

Left front
rail of
cabinet rack
Rail
tapped
for 10-32
(A) Front rail tapped for 10-32 screws
1
10-32
PHS
screw
(2)
.
(8) Untapped front rail
Rackmounting- Type 453/R453
*Note:
Use FHS screws if front rail holes
are countersunk.
Fig. 6-5. Methods of mounting the stationary section to the front rails.
©
Securing
holes
!tapped for
10-32
screws l
31/4 inch minimum
3 % inch minimum
Y2 inch (for correct
position of
securing holes)
Fig. 6·6. Locating the mounting holes for the left stationary section. Same dimensions apply to right stationary section.
6-5